My Rage Cage Arrived Yesterday. The Pin and locking mechanism are useful, but the pin has a very small pin hole for a small pad lock, and not large enough to accommodate the lock I had been using on my CB-6000. Last night I removed the pin entirely and used my main stay lock in place of the pin and lock system.
Today after work, I went by The Tire and bough a package of bolts and nuts, that would fit the pin hole, where the pin is inserted into the top of the base ring. I tightened a bolt with a couple of nuts in the pin hole to lock the base ring together, because the cage portion has an arm that fits onto the wings of the base ring (it fits together in two parts).
Once you fit the cage arm over the base ring, comprising the pin hole for locking, you have two interlocking parts that lock the device together, then you have to either use the pin and lock to lock the device closed, or like I did today, I am using a bolt and nut in place of the pin system.
I took my metal solder set and soldered the end of the bolt behind the nuts permanently sealing the bolt in solder.
My Rage Cage is permanently sealed now.
I cannot take it off now.
Let’s ROCK !!!